HANcoder

From OpenMBD
< Downloads
Revision as of 17:07, 7 November 2019 by Hugo (talk | contribs)
Jump to: navigation, search

HANcoder STM32 Target Download instructions

There are two options for downloading and installing HANcoder STM32 Target.
Option 1 is to download and install an example project that combines HANcoder STM32 Target and the OpenBLT bootloader.
Option 2 is to download and install the latest-and-greatest version of HANcoder STM32 Target source code and the OpenBLT bootloader separately.
Both options are described on this page.


Option 1: A complete HANcoder STM32 Target + OpenBLT example project

These complete example projects show how HANcoder STM32 Target folders and OpenBLT folders should be combined.

 HANcoder STM32 Target 1.0 + OpenBLT v1.0.1: Download
 HANcoder STM32 Target 1.1 Beta + OpenBLT v1.0.1: Download
 This is a Beta release.
 If you are not sure this release is for you, please download HANcoder 1.0 instead.
 This release adds the following support for the STM32 Olimexino target:
 - XCP over UART
 - servo motor control
 - variable frequency for PWM outputs
 - signal tower


Option 2: HANcoder STM32 Target Source code

If you would like to use the latest-and-greatest version of HANcoder STM32 Target, than the source code is available for download on GitLab
HANcoder STM32 Target works best with OpenBLT V1.0.1 bootloader running on the STM32 target microcontroller and the MicroBoot PC application for communication with the bootloader. These are, however, not provided on GitLab and should installed manually.

OpenBLT binaries

OpenBLT bootloader version 1.0.1 by Feaser can be used for flash programming the STM32 target microcontrollers.
The binaries of the bootloaders are available for download: File:OpenBLT v1.0.1 Bootloaders.zip
Howto install such a bootloader initially is described in the Installation manual.

Note: OpenBLT bootloader source code is available here:

MicroBoot

The MicroBoot PC application as described in the Installation manual needs to be downloaded and installed separately: File:Microboot.zip

The location of the MicroBoot application cannot be chosen freely, because several scripts use paths relative to the installation folder Therefore make sure that the Host folder is at the same level as the Target folder:

 ./Host
    |
    +- /MicroBoot
    |    |
    |    +- MicroBoot.exe
    |    +- ...
 ./Target
    |
    +- /blockset
    +- /Development tools
    +-  ...

Tip 1: Have look at the combined HANcoder STM32 Target + OpenBLT example projects above for an example.

Tip 2: An easy way to get the latest GitLab version in a fully prepared environment:
1. Download one of the example projects
2. In the example project, replace the Target folder with the Target folder as provided on GitLab.


HANcoder RC30 Target

HANcoder RC30 is available upon request in open and closed source version.