Difference between revisions of "HANcoder/STM32/Blocks/Get Free Running Counter"
From OpenMBD
(One intermediate revision by the same user not shown) | |||
Line 23: | Line 23: | ||
| The block execution time, the amount of time between consecutive executions of the block. 0.1 means the the block will be executed at 10 Hz | | The block execution time, the amount of time between consecutive executions of the block. 0.1 means the the block will be executed at 10 Hz | ||
|} | |} | ||
− | |||
− | |||
− | |||
{{HANcoder/BlockFooter| | {{HANcoder/BlockFooter| | ||
− | |SeeAlso = [[HANcoder/Compare_Event_IRQ| Compare Event IRQ]] {{!}} [[HANcoder/Get_Last_Event_Counter| Get Last Event Counter]] {{!}} [[HANcoder/Output_Compare_Init| Output Compare Init]] {{!}} [[HANcoder/Reset_Free_Running_Counter| Reset Free Running Counter]] {{!}} [[HANcoder/Schedule_Compare_Event| Schedule Compare Event]] | + | |SeeAlso = [[HANcoder/STM32/Blocks/Compare_Event_IRQ| Compare Event IRQ]] {{!}} [[HANcoder/STM32/Blocks/Get_Last_Event_Counter| Get Last Event Counter]] {{!}} [[HANcoder/STM32/Blocks/Output_Compare_Init| Output Compare Init]] {{!}} [[HANcoder/STM32/Blocks/Reset_Free_Running_Counter| Reset Free Running Counter]] {{!}} [[HANcoder/STM32/Blocks/Schedule_Compare_Event| Schedule Compare Event]] |
}} | }} |
Latest revision as of 10:27, 5 May 2017
Supported Targets: Olimexino, E407, P405
Contents
General information about Get Free Running Counter
This block reads the timer module's internal 16-bit free running counter value.
Block
Mask
Outputs (outports)
.[uint16]
Block parameters
Parameter | Description |
---|---|
Timer module | Select the timer module to use |
Sample time | The block execution time, the amount of time between consecutive executions of the block. 0.1 means the the block will be executed at 10 Hz |
See Also
Compare Event IRQ | Get Last Event Counter | Output Compare Init | Reset Free Running Counter | Schedule Compare Event