View source for HANcoder/STM32/Blocks/Save EEPROM
You do not have permission to edit this page, for the following reason:
You can view and copy the source of this page.
Templates used on this page:
Return to HANcoder/STM32/Blocks/Save EEPROM.
You do not have permission to edit this page, for the following reason:
The action you have requested is limited to users in one of the groups: Administrators, Bureaucrats.
You can view and copy the source of this page.
Templates used on this page:
Return to HANcoder/STM32/Blocks/Save EEPROM.
Supported Targets: Olimexino, E407, P405
The STM32 controller does not have dedicated EEPROM on-chip. All EEPROM write, read and erase operations are therefore performed in a RAM buffer. To make sure RAM buffer contents are still valid after a power-off, its contents needs to be save in flash EEPROM, which is achieved with this block. This is typically called during the software shutdown sequence, right before power off.
Trigger Port Connect the port to a trigger source to execute the block only when necessary.