Difference between revisions of "HANcoder/STM32/Blocks/UDS Get Seed"
From OpenMBD
(2 intermediate revisions by the same user not shown) | |||
Line 22: | Line 22: | ||
| The block execution time, the amount of time between consecutive executions of the block. 0.1 means the the block will be executed at 10 Hz. | | The block execution time, the amount of time between consecutive executions of the block. 0.1 means the the block will be executed at 10 Hz. | ||
|} | |} | ||
− | |||
− | |||
− | |||
{{HANcoder/BlockFooter| | {{HANcoder/BlockFooter| | ||
− | |SeeAlso = [[HANcoder/UDS_Get_Key|UDS Get Key]] {{!}} [[HANcoder/ | + | |SeeAlso = [[HANcoder/STM32/Blocks/UDS_Get_Key|UDS Get Key]] {{!}} [[HANcoder/STM32/Blocks/UDS_Get_Seed_Event|UDS Get Seed Event]] {{!}} [[HANcoder/STM32/Blocks/UDS_Init|UDS Init]] {{!}} [[HANcoder/STM32/Blocks/UDS_Set_Key_Verified|UDS Set Key Verified]] {{!}} [[HANcoder/STM32/Blocks/UDS_Set_Seed|UDS Set Seed]] {{!}} [[HANcoder/STM32/Blocks/UDS_Verify_Key_Event|UDS Verify Key Event]] |
}} | }} |
Latest revision as of 10:37, 5 May 2017
Supported Targets: Olimexino, E407, P405
Contents
General information about UDS Get Seed
This block reads the 32-bit seed value to be used in the seed/key unlock sequence.
Block
Mask
Outputs (outports)
Seed value to be used in the seed/key unlock sequence.[uint32]
Block parameters
Parameter | Description |
---|---|
Sample time | The block execution time, the amount of time between consecutive executions of the block. 0.1 means the the block will be executed at 10 Hz. |
See Also
UDS Get Key | UDS Get Seed Event | UDS Init | UDS Set Key Verified | UDS Set Seed | UDS Verify Key Event