Getting Started
In this section you can find the links to get started with the different tools. One of the tools, HANcoder, is an addition for MATLAB Simulink® to be able to generate code for an embedded controller. At the moment two different kind of embedded controllers are supported:
- STM32 microcontroller prototype boards by Olimex
- Automotive specification series production ECU's by Bosch Rexroth: RC30 series
When HANcoder is used to program one of the controllers specified above it is possible to read signals and write parameters from and to the controller with HANtune. This monitoring and calibration tool is also capable of displaying and sending data on a CAN bus.
HANcoder STM32
To get started just follow our step-by-step online Installation Manual
The installation procedure is also available as pdf, choose the pdf matching your hardware board:
Getting Started Guide Olimexino.pdf
Getting Started Guide STM32E407.pdf
Getting Started Guide STM32P405.pdf
Need hardware? Check the STM32 page for more information about which prototype boards are supported.
HANtune
To get started with HANtune download the zipfile unzip it and follow the Quick Start
Rexroth RC30
To get started with the RC30 Target, please contact jan.benders@han.nl
