Difference between revisions of "HANcoder/STM32/Blocks/UART Send"
From OpenMBD
Line 11: | Line 11: | ||
== Outputs (outports) == | == Outputs (outports) == | ||
− | When the status output is 0, the | + | When the status output is 0, the transmit has failed. |
== Block parameters == | == Block parameters == |
Revision as of 15:21, 28 April 2017
Supported Targets: Olimexino, E407, P405
Contents
General information about UART Send
This block transmits a byte on the UART communication interface.
Block
Mask
Inputs (inports)
The input to this block is the byte to send.
Outputs (outports)
When the status output is 0, the transmit has failed.
Block parameters
Parameter | Description |
---|---|
Channel | Select channel for UART communication |
Use status output | When this checkbox is ticked an extra output appears which show the status of the reception buffer. |
Sample time | The block execution time, the amount of time between consecutive executions of the block. 0.1 means the the block will be executed at 10 Hz. |