CAN Receive
From OpenMBD
< HANcoder | STM32 | Blocks
Revision as of 09:03, 5 April 2017 by Jasonvankolfschoten (talk | contribs)
Supported Targets: Olimexino, E407, P405
General information about CAN Receive
Reads a CAN message that has been received. If a CAN message with the same identifier is received more than once between executions of this block the data of the last message will be displayed.
Block
Mask
Parameter | Description |
---|---|
CAN channel | The CAN channel to be used, the E407 and P405 have two CAN channels, the Olimexino has only one. |
Output ports | The number of output ports, the maximum number of bytes in a message is 8 so the maximum number of output ports is also 8. If for example uint16's are received you can only receive 4 per message so you can select a maximum of 4 output ports per message. |
Ouput data type | The output data type to be used. This assumes all signals in a message are the same datatype. If this is not the case then just use uint8 and do the
processing of the bits and bytes in Simulink. |
Byte order | Byte order or endianness can be selected. If the checkbox is selected then the Most Significant Byte order, big-endian or Motorola order is used, if not then the Lease Significant Byte, little-endian or Intel order is used. |
Sample time | Sample time of the block. The Sample time (in seconds) defines the rate at which the block is visited by the real-time scheduler of the target. The value of the Sample time has to be an integer multiple of the base sample time of the model. |