Difference between revisions of "HANcoder/STM32/Blocks/UDS Verify Key Event"
(Created page with "{{HANcoder/block| info= A 'UDS Verify Key Event' block is needed when the parameter 'UDS seed/key required' is set to TRUE (checked) in the 'UDS Init' block. This block has...") |
|||
(3 intermediate revisions by 2 users not shown) | |||
Line 1: | Line 1: | ||
{{HANcoder/block| | {{HANcoder/block| | ||
info= | info= | ||
− | + | This block has a function call output that gets triggered during a seed/key sequence, when the UDS module received a 32-bit key from the tester that needs to be verified. The connected subsystem should contain a 'UDS Set Key Verified' block to inform the UDS module if the received key was correct. | |
− | + | A 'UDS Verify Key Event' block is needed when the parameter 'UDS seed/key required' is set to TRUE (checked) in the 'UDS Init' block. | |
− | |||
− | This block has a function call output that gets triggered during a seed/key | ||
− | sequence, when the UDS module received a 32-bit key from the tester that | ||
− | needs to be verified. The connected subsystem should contain a 'UDS Set Key | ||
− | |||
− | |||
− | |||
− | ''' | ||
− | |||
− | |||
− | |||
|blockImage=UDSVerifyKeyEvent.png | |blockImage=UDSVerifyKeyEvent.png | ||
− | |||
− | |||
|maskImage=UDSVerifyKeyEventMask.png | |maskImage=UDSVerifyKeyEventMask.png | ||
+ | }} | ||
+ | == Outputs (outports) == | ||
+ | The output port allows the connection of a function call subsystem. It can also be terminated when not in use. | ||
− | + | {{HANcoder/BlockFooter| | |
− | + | |SeeAlso = [[HANcoder/STM32/Blocks/UDS_Get_Key|UDS Get Key]] {{!}} [[HANcoder/STM32/Blocks/UDS_Get_Seed|UDS Get Seed]] {{!}} [[HANcoder/STM32/Blocks/UDS_Get_Seed_Event|UDS Get Seed Event]] {{!}} [[HANcoder/STM32/Blocks/UDS_Init|UDS Init]] {{!}} [[HANcoder/STM32/Blocks/UDS_Set_Key_Verified|UDS Set Key Verified]] {{!}} [[HANcoder/STM32/Blocks/UDS_Set_Seed|UDS Set Seed]] | |
}} | }} |
Latest revision as of 10:40, 5 May 2017
Supported Targets: Olimexino, E407, P405
Contents
General information about UDS Verify Key Event
This block has a function call output that gets triggered during a seed/key sequence, when the UDS module received a 32-bit key from the tester that needs to be verified. The connected subsystem should contain a 'UDS Set Key Verified' block to inform the UDS module if the received key was correct. A 'UDS Verify Key Event' block is needed when the parameter 'UDS seed/key required' is set to TRUE (checked) in the 'UDS Init' block.
Block
Mask
Outputs (outports)
The output port allows the connection of a function call subsystem. It can also be terminated when not in use.
See Also
UDS Get Key | UDS Get Seed | UDS Get Seed Event | UDS Init | UDS Set Key Verified | UDS Set Seed