Difference between revisions of "HANcoder/STM32/Blocks/XCP On USB Config"
(Created page with "{{HANcoder/block| info= A 'XCP Config' block instructs the code generator to include the XCP over USB protocol, the XCP protocol is used for communication with HANtune. A USB...") |
|||
(3 intermediate revisions by the same user not shown) | |||
Line 11: | Line 11: | ||
XCPOnUSBConfigMask.png | XCPOnUSBConfigMask.png | ||
+ | }} | ||
+ | |||
+ | {{HANcoder/BlockFooter| | ||
+ | |SeeAlso = [[HANcoder/STM32/Blocks/XCP_On_CAN_Config| XCP on CAN config]] | ||
}} | }} |
Latest revision as of 10:25, 5 May 2017
Supported Targets: Olimexino, E407, P405
General information about XCP On USB Config
A 'XCP Config' block instructs the code generator to include the XCP over USB protocol, the XCP protocol is used for communication with HANtune. A USB communication stack is automatically included that makes the controller show up as a virtual COM port on the PC. Use the Windows Device Manager to determine the COM port number. Configure 115200 bits/sec as the communication speed on the PC side.