Difference between revisions of "HiL Installation Guide"
From OpenMBD
(Created page with "This page is a walkthrough on setting up a HiL Simulator. The following components are required: * 2x STM32-E407 Boards * Lely GCB (With Linux installed) * Network Switch (...") |
(→Set-Up) |
||
| Line 12: | Line 12: | ||
== Set-Up == | == Set-Up == | ||
| − | To set-up the simulation, follow the guide [[Media:HiL_setup.pdf]]. | + | To set-up the simulation, follow the guide [[Media:HiL_setup.pdf|HiL Set-up Guide]]. |
| − | |||
| − | |||
Revision as of 14:37, 20 December 2018
This page is a walkthrough on setting up a HiL Simulator.
The following components are required:
- 2x STM32-E407 Boards
- Lely GCB (With Linux installed)
- Network Switch (Router also possible)
- Power Sources for each component
- Cables to connect each component (Elaborated in walkthrough file)
Set-Up
To set-up the simulation, follow the guide HiL Set-up Guide.
