Difference between revisions of "HiL Installation Guide"
From OpenMBD
(→Set-Up) |
|||
(3 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
This page is a walkthrough on setting up a HiL Simulator. | This page is a walkthrough on setting up a HiL Simulator. | ||
+ | |||
+ | [[File:HiL_schematic.png|600px]] | ||
Line 9: | Line 11: | ||
* Power Sources for each component | * Power Sources for each component | ||
* Cables to connect each component (Elaborated in walkthrough file) | * Cables to connect each component (Elaborated in walkthrough file) | ||
− | |||
== Set-Up == | == Set-Up == | ||
− | To set-up the simulation, follow the guide [[Media:HiL_setup.pdf|HiL Set-up Guide]]. | + | To set-up the simulation demo, download and follow the guide [[Media:HiL_setup.pdf|HiL Set-up Guide]]. |
Latest revision as of 09:34, 19 March 2019
This page is a walkthrough on setting up a HiL Simulator.
The following components are required:
- 2x STM32-E407 Boards
- Lely GCB (With Linux installed)
- Network Switch (Router also possible)
- Power Sources for each component
- Cables to connect each component (Elaborated in walkthrough file)
Set-Up
To set-up the simulation demo, download and follow the guide HiL Set-up Guide.