HiL Installation Guide
From OpenMBD
Revision as of 14:30, 20 December 2018 by Willard de Jong (talk | contribs) (Created page with "This page is a walkthrough on setting up a HiL Simulator. The following components are required: * 2x STM32-E407 Boards * Lely GCB (With Linux installed) * Network Switch (...")
This page is a walkthrough on setting up a HiL Simulator.
The following components are required:
- 2x STM32-E407 Boards
- Lely GCB (With Linux installed)
- Network Switch (Router also possible)
- Power Sources for each component
- Cables to connect each component (Elaborated in walkthrough file)
Set-Up
To set-up the simulation, follow the guide Media:HiL_setup.pdf.
==