Difference between revisions of "CI/SonarQube"
| Line 12: | Line 12: | ||
== Installation == | == Installation == | ||
| − | + | The following steps must be followed to install SonarQube and SonarQube Scanner. | |
| + | |||
| + | For SonarQube: | ||
| + | |||
| + | In Command Prompt go to the map where SonarQube is installed and start the service, for example: | ||
| + | |||
| + | C:\Program Files\SonarQube\sonarqube-5.6.6\bin\windows-x86-64>StartSonar.bat | ||
| + | |||
| + | If the service is up, SonarQube is installed properly. | ||
| + | |||
| + | [[File:cmdsq.png|400px]] | ||
| + | |||
| + | This can be checked by the following link: [http://localhost:9000/| SonarQube]. | ||
| + | |||
| + | On the picture below, on the left side of the screen it shows that the SonarQube server is successfully started. | ||
| + | |||
| + | [[File:localhost9000.png|400px]] | ||
| + | |||
| + | To change the default port, under the header "WEB SERVER" in the file sonar.properties in the map of SonarQube, the # must be removed and now the sonar.web.port can be changed, for example to 5900. | ||
| + | |||
| + | [[File:sonar_web_port.jpg|400px]] | ||
| + | |||
| + | For SonarQube Scanner: | ||
| + | |||
| + | The following link can be used to install SonarQube Scanner: [https://docs.sonarqube.org/display/SCAN/Analyzing+with+SonarQube+Scanner SonarQube Scanner]. | ||
| + | These settings must be filled in the project settings in Jenkins (see "Execute SonarQube Scanner"). | ||
== Configuration == | == Configuration == | ||
| + | |||
<i>Configuration Procedure</i> | <i>Configuration Procedure</i> | ||
Revision as of 13:07, 31 October 2017
Introduction to SonarQube
Short explanation of what SonarQube is here and why we chose SonarQube...
Installation
The following steps must be followed to install SonarQube and SonarQube Scanner.
For SonarQube:
In Command Prompt go to the map where SonarQube is installed and start the service, for example:
C:\Program Files\SonarQube\sonarqube-5.6.6\bin\windows-x86-64>StartSonar.bat
If the service is up, SonarQube is installed properly.
This can be checked by the following link: SonarQube.
On the picture below, on the left side of the screen it shows that the SonarQube server is successfully started.
To change the default port, under the header "WEB SERVER" in the file sonar.properties in the map of SonarQube, the # must be removed and now the sonar.web.port can be changed, for example to 5900.
For SonarQube Scanner:
The following link can be used to install SonarQube Scanner: SonarQube Scanner. These settings must be filled in the project settings in Jenkins (see "Execute SonarQube Scanner").
Configuration
Configuration Procedure
