PWM Duty Cycle
From OpenMBD
< HANcoder | STM32 | Blocks
Revision as of 11:40, 21 April 2017 by Jasonvankolfschoten (talk | contribs)
Supported Targets: Olimexino, E407, P405
Contents
General information about PWM Duty Cycle
A 'PWM Duty Cycle' block allows the duty cycle of the generated PWM signal to changed. Note that this only works properly if a 'PWM Init' block is also present for initializing the related PWM module.
Block
Mask
Block inputs (inports)
Input: The value of the duty cycle in 100/1023[%].(512 = 50%).(uint16)
Block parameters
Parameter | Description |
---|---|
Output pin | Select the output pin where the PWM signal should be generated. |
Sample time | Sample time of the block. The Sample time (in seconds) defines the rate at which the block is visited by the real-time scheduler of the target. The value of the Sample time has to be an integer multiple of the base sample time of the model. |